Design: Tarek v2 3D Printed Face Shield

 

Pros: 

  • Simple unibody approach
  • Mylar sheet slides into the fitting without need for modification (holes/shaping) -- gribs very tight; thus a pain to install but I doubt would fall out

 

 

 

Cons: 

  • depending plastic thickness for mylar may get excessive bowing on inferior portion (could use a brace like Prusa's version)
  • attachment points for band are minimal; at a junction that is designed to be load bearing 

References:

All the 3D files

https://github.com/GliaX/faceshield


Leave a comment

Please note, comments must be approved before they are published